How to Install Your At-Home Permanent Bracelet

✨ How to Install Your Forever Bracelet

Welcome to your Pretty Pickie DIY Permanent Jewelry Kit. You've got the tools, the chain, and the sparkle — now let's create something forever-worthy.

Watch the video above to see the full installation process in action. Then follow the easy steps below to install your bracelet safely and securely from home.

1. Wrap It & Check the Fit
Gently wrap the chain around your wrist (or ankle) to find your perfect length. You want it snug and comfortable — like a little piece of sparkle that won't slip off.

2. Snip the Extra Chain
Use your wire cutters to trim off any extra length. Hold the chain steady and make one clean snip.

3. Open the Jump Ring
Grab your pliers and gently twist open the small round ring at the end. Twist sideways — not like you're pulling it apart. Let the motion do the work.

4. Connect Both Ends
Hook both ends of the chain onto the open jump ring. Make sure each end is sitting on the ring before moving to the next step.

5. Do a Final Check
Try it on and make sure it feels exactly how you want it. Once it's locked, it's locked — so double-check before the final close.

6. Close It Securely
Use your pliers to twist the jump ring closed until there's no visible gap. Give it a gentle squeeze to make sure everything is locked in tight.

7. Wear It Like You Mean It
That's it! You just installed your very own forever bracelet — no welder, no stress, just you and your sparkle. ✨

Keep in mind: Your permanent bracelet is designed to be worn 24/7. It's water-resistant and built to last. If you ever need to remove it, any jeweler can do so safely.

Show us your sparkle! Tag @prettypickie on Instagram to share your new forever bracelet.